Installation (EMIS)

JoyConnect Set-up Guide - EMIS

Follow this guide to install JoyConnect πŸš€

Step 1: Open up EMIS

Step 2: Open up the client record of a 'dummy' or 'real' patient on EMIS

Step 3: Download the Sharepoint file that has been sent to you 

https://builds.thejoyapp.com/joyconnect/installers/JoyConnect.Installer.1.0.49.msi
  • When this file lands in your downloads folder it will be marked as unsafe so you will need to follow these steps to keep the download:

    1. Click the 3 dots next to the file 
    JoyConnect 1
    2. Click 'Keep'
    JoyConnect 3
    3. Click 'Show more'
    4. Click 'Keep anyway' 
    JOYCONNECT 2

Step 4: Click to open the file that has been downloaded

  • Once you have opened the file you will see this window
  • Click 'More info':
    JoyCOnnect 4
  • Then click 'Run anyway' 
    Joyconnect 5

Step 5: You will need to click install when this window appears

tempsnip-Feb-09-2024-11-10-56-3797-AM

  • You will see the below screen when JoyConnect is installing

joyconnect install

  • You will see this screen to confirm that JoyConnect is installed

joyconnect finish install

Step 6: Install .net (if required)

  • If you don't have .net installed it will prompt you to install .net
  • If you do have .net installed skip to Step 6
  • Once this is finished installing you will have to restart JoyConnect

Step 7: Restart JoyConnect

1. Open Task Manager

Joyconnect 5-1

2. Find JoyConnect and click on it 

3. Click 'end task'

Joyconnect 6

4. Open it up again by using the start menu and clicking on the JoyConnect application

Joyconnect 7

Step 8: Approve JoyConnect

  • An EMIS pop-up will appear where you will have to put in your EMIS username and password to approve JoyConnect
    joyconnect 8
  • Please note that this window may take a few minutes to appear
  • if you do not see the JoyConnect account creation window then please repeat Step 7 and restart JoyConnect
  • A JoyConnect application icon should have appeared on the taskbar at the bottom of the screen

Step 9: Create an account on JoyConnect

  • Follow the account creation instructions which will require you to put in an email and password that you can create (it must be 12 characters) then click on the tickbox
  • Click Create 

Screenshot (76)

 

The expected result is that if you have a patient open (dummy or real) then the JoyConnect widget should appear in the bottom right of your screen🌟

joyconnect 9

tempsnip-Feb-07-2024-03-09-59-7938-PM